4PKS 2.4GHZ FASST R614FF

FUTK4901

This is the Futaba 4PK Pistol Grip Transmitter and the R614FF Receiver
with the 2.4GHz FASST system for surface use. Servos are not included.
FEATURES:

Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts very quickly virtually eliminating signal conficts and interruptions unlike other 2.4GHz systems that only stay on one or two frequencies
New features are the 4-wheel steering mixing for better rock crawling capabilities, plus new Updating program

Pre-Vision Packet Screening technology scans incoming data for potential problems and applies sophisticated error correction
techniques for solid impenetrable link with model

Easy Link system features a unique ID code in the transmitter that links to the receiver insuring that receiver only follows commands
from this transmitter-with over 134 million possible codes there is no chance for a conflict

"New Driver" "Race Ready" "Expert" and "Big Car" menus that add functions based on skill level and experience

Throttle Mode Select for selecting acceleration/brake servo neutral points between 70/30 for nitro or 50/50 for electrics, throttle programming options including 5-point curve, expo and VTR

Slide the power switch to "display" to set up without transmitting-use one of the four menus provided or create a custom menu, optimize response for analog or digital/brushless servos, set up two sets of dual rates, choose two Condition Select functions, restore factory settings with the adjuster function, or adapt electronic speed control to HRS frame rates with MC link
Traction control/acceleration rate
Custom menu assignments
Data transfer
ABS braking
Boat mixing-in addition to great performance in R/C car and truck applications, this system is also ideally suited to the rigors of
boat racing
Direct Select single button acccess to eight preassigned functions

Forty model memory with ten character model naming

Fourth channel for 4WS crawlers, transponders, brake bias and more

VTR, acceleration, speed, expo, mode, tension and 5-point curve (throttle)
Two programmable mixes
Electronic and mechanical ATL (brake side only)

Condition select 2
Programmable battery fail safe
Start function/engine cut
Right/Left hand use
Channel 1-4 fail safes
Assignable buttons and dials
Digital trims memory and reset
Navigation lap timer that sounds when target lap time is exceeded, up, down lap and systems timers

One year limited warranty through manufacturer beginning at date of purchase INCLUDES:

4PK Pistol Grip Transmitter R614FF Receiver 1700mAh 6V Transmitter Battery HBC-3B(4) 120V AC Battery Charger
Switch Harness Wheel Adapter Small Screwdriver Manual
REQUIRES:

Servos of modeler's choice (digital servos can be used in Normal or High Speed Mode, analog servos must be used in Normal Mode)
SPECS:

Transmitter-
Power Requirement:NiMH 6V battery (included)
4 AA batteries Current Drain: 250mA or less (vibration and back lighting off)

Battery Charger- Input: 120V AC, 60Hz 5W Output: TX 6 VDC 170mA RX 6 VDC 100mA
Receiver-
Size: 1.38 x 0.91 x 0.33" (35.1 x 23.2 x 8.5mm)
Weight: 0.28oz (7.8g) Operating Voltage: 3.5 - 8.4V Current Drain: 135mA or less
COMMENTS:

The 4PK is also compatible with the R603FS, R603FF and R604FS receivers. If wanting a LiFe battery for the transmitter, the Hobbico LiFe 6.6V 1900mAh 2 Cell Battery Pack is an ideal choice. Screen protector for this is optional part number.