FLATANA PROFILE ELECTRIC 3-D P

GPMA1111

This is a radio controlled, electric powered, foam
Great Planes FlatOuts Flatana 3D Profile Park Flyer Airplane.
For Intermediate to Advanced Modeler/Fliers.

FEATURES: Construction: 1/8" (3mm) thick foam w/ carbon fiber reinforcing rods
to strengthen the infrastructure
Trim: Blue, Red, White, Yellow, Green and Light Blue coloring
Wings: 1/8" (3mm) thick foam with with carbon fiber leading edge
and trailing edge reinforcement
Landing gear: Carbon fiber rods and composite axle supports
Wheel Pants: 1/4" (6mm) thick White foam construction
Building Time: Flight ready in 2-3 hours
Hardware: Carbon fiber pushrods and wing struts, clip-hinge system
on tail section allows up to 80° of deflection without binding and
also pops loose in the event of a crash
Motor: T-370 size Brushed (GPMG0310)
Gearbox: 5:1 gear ratio, ball bearing-supported
Propeller: 10x3.8 Slo-Flyer with prop saver
Warranty: Great Planes Model Manufacturing Company guarantees this
kit free from defects in both materials and workmanship at
the date of purchase.

INCLUDES: Flatana foam construction 3D airplane, 370 size motor, 5:1 gearbox,
10x3.8 Slo-Flyer prop, prop saver, carbon fiber rods and tubes,
complete hardware package and photo-illustrated manual

REQUIRES: Speed Control: 7+A continuous current
Battery: 3S 350-700mAh Lithium Polymer (LiPo) battery
**For optimum performance battery weight should not exceed
2.3oz (65g).**
Charger: Lithium Polymer capable
Radio: 4-channel with micro receiver
Servos: 3 micro with a 15+ oz-in minimum torque rating
Misc. Items: Foam-safe CA, building and field equipment

SPECS: Wingspan: 36" (915mm)
Wing Area: 241 sq in (15.5 sq dm)
Weight: 7.5 - 9oz (215 - 225g)
Wing Loading: 5oz/sq ft (15g/sq dm)
Length: 31.5" (800mm)
Airfoil: Flat plate
Center of Gravity: 2.5" (63mm) Back from the wing's leading edge
at the fuselage sides.
Control Throws-

Function High rate endpoints High rate travel High rate exponential
Aileron +/- 100% +/- 55-60° 40%
Elevator +/- 100% +/- 55-60° 40%
Rudder +/- 100% +/- 55-60° 40%
Low rate endpoints Low rate travel Low rate exponential
Aileron +/- 40% +/- 15-25° 0%
Elevator +/- 40% +/- 15-25° 0%
Rudder +/- 40% +/- 15-25° 0%

COMMENTS: The ElectriFly 720mAh battery is not capable of delivering the
current required by this system.

If wanting an ultra micro receiver for competition flying only one is
required depending on the channel of the radio selected (Low band
Ch 11-35, High band Ch 36-60). Please note the Accessory Completion
Guide lists both Low and High band receivers.
Channel selection is left to the modeler's preference

Please note that if you are ordering the Futaba 4YF (FUTJ36**) listed
in the Accessory Completion Guide you will only need one more S3114
servo, part number FUTM0414.

If you are ordering the Micro receiver R124F you will need to order
the S3114M servos, or servos with micro connectors. These are
usually identified with an (M) located after the numbers such as
S3114M.