PLUMA 3D EP ARF

GPMA1130

This is the electric powered, radio controlled, almost ready to fly
ElectriFly by Great Planes Pluma 3D Biplane.
For Intermediate Modeler/Pilots.
Can be flown indoors or outdoors.

FEATURES: Construction: Lightweight 0.12" (3mm) extruded polystyrene Pro-
Formance foam-an ElectriFly exclusive, tabbed and interlocking for
fast assembly and correct alignment, pre-applied graphics are
lighter weight than paint
all flying surfaces (except rudder) pre-hinged with genuine 3M
Blenderm tape which is durable and feather light
Wings: Both sections with ailerons, speed brakes install between
aileron link rods if desired
Aileron Control: Single servo
Landing Gear: Carbon rod with factory bent wire ends
Hardware: Carbon fiber and laser cut
Building Time: Ready to fly in about one hour
Warranty: Great Planes Model Manufacturing Company guarantees this
kit free from defects in both materials and workmanship at
the date of purchase.

INCLUDES: ElectriFly by Great Planes Pluma 3D Biplane, instruction manual,
decal sheet, landing gear with two 1" (26mm) diameter plastic
wheels

REQUIRES: Radio: 4 channel
Servos: Three micro high torque (1-rudder, 1-elevator, 1-aileron)
Battery Charger: LiPo compatible
For Indoor Flight-
Motor: Rimfire Outrunner Brushless 28-22-1380, GPMG4505
ESC: Silver Series For Brushless Motors 8A, GPMM1800
Battery: Power Series 11.1V 300mAh Balanced 18C LiPo Pack, GPMP0595
Propeller: 8x4 thin prop, GWSQ2009

For Outdoor Flight-
Motor: Rimfire Outrunner Brushless 28-26-1000, GPMG4525
ESC: Silver Series For Brushless Motors 12A, GPMM1810
Battery: Power Series 11.1V 640mAh Balanced 20C LiPo Pack, GPMP0601
Propeller: 10x4.7 Slow Flyer, APCQ5015

SPECS: Wingspan: 32.5" (830mm)
Wing Area: 518 sq in (33.4 sq dm)
Weight: 8.4 - 9.5oz (240 - 270g)
Wing Loading: 2.3 -2.6oz/sq ft (7.2 - 8.1g/sq dm)
Length: 38" (955mm)
Center of Gravity:
Indoor Flying, 2-5/8" (67mm) from the leading edge of upper wing
Outdoor Flying, 2-1/2" (63mm) from the leading edge of upper wing
Total C.G. range is from 1-3/4" (44mm) forward to 3-5/16"
(85mm) aft. Do not fly outside of this range
Control Throws-
Low Rate High Rate 3D Rate
Elevator: 1" (25mm) 17° 1-3/8" (35mm) 26° 2-1/8" (55mm) 46°
Rudder: 1-9/16" (40mm) 19° 2-3/4" (70mm) 36° 3-7/8" (100mm) 56°
Ailerons: 1-9/16" (40mm) 27° 2-3/8" (60mm) 43° 2-7/8" (75mm) 58°